top of page

Winter Ready Moisturizer + Natural Version

19 minutes ago
3 min read


Winter Ready Moisturizer for Dry Sensitive Skin

(use on face or body)


Directions:

  1. In a heat safe and sanitized container mix together the phase A ingredients.  The Allantoin will not dissolve until we heat it up. 

  2. In another sanitized container, combine the phase B ingredients. 

  3. Next, Tare scale and write down how much phase A weighs. (Including the beakers weight too) we are going to heat everything up and some of the water may evaporate. We will need to replace that water loss after it’s heated. You can heat using a water bath (fill a pan with about an inch of water over your stove top on medium heat and place your beakers in) I used a Hot Plate to heat my two phases.

  4. Cover both phase A and B with foil while heating.

  5. Heat until phase B has melted and both phases are around the same temperature. (70°C/158°F )

  6. Now remove phase A from heat and place on scale and replace any water that evaporated. Normally it's about 1 gram or less. (The heat from the beaker can mess with the scale, so place a barrier between the two)

  7. Remove phase B from heat and pour phase A into phase B (Pour water phase into oil phase)

  8. Immediately mix with an immersion blender/stick blender. & Let Cool (don’t mix with immersion blender again once it starts to thicken. This can add too much air into the lotion)

  9. Once your lotion has cooled to 104°F / 40°C add in the phase C ingredients and hand mix. (Don’t mix with the immersion blender)

  10. Let sit overnight covered with Plastic Wrap to fully cool before pouring into bottles. 


Benefits/Uses of Ingredients;

  • Propanediol - Humectant

  • Allantoin - moisturizing, hydrating, and soothing/anti-irritant Learn more HERE

  • Ritamulse SCG (INCI: Glyceryl Stearate & Cetearyl Alcohol & Sodium Stearoyl Lactylate) - Emulsifier (Water in Oil) and thickener

  • Cetyl Alcohol - co emulsifier, thickener, & emollient

  • Shea Butter (INCI: Butyrospermum Parkii (Shea) Butter) - emollient

  • Pumpkin Seed Oil, ORG (INCI: Cucurbita Pepo (Pumpkin) Seed Oil) - emollient

  • Caprylic/Capric Triglyceride - emollient

  • Dimethicone - helps seal and lock in moisture. also increases spreadability

  • Petrolatum - occlusive that helps seal and lock in moisture and increase TEWL.

  • Glycerin - humectant

  • Phenonip® XB (INCI: Phenoxyethanol (and) Methylparaben (and) Ethylparaben (and) Propylparaben) - Preservative. *I know people do not like parabens, but parabens are a very gentle and mild preservative and is recommended for sensitive skin, which is why I am using it. This is gentle enough that it is eye area safe

  • Vitamin E T-50 (INCI: Tocopherols, Helianthus Annuus Seed Oil) - antioxidant



Natural Alternative Winter Ready Moisturizer



Changes I Made to Make it Natural;


I switched out the Petrolatum, for a natural alternative called Biolatum™.


I also switched out the Allantoin, which is a natural identical ingredient for Aloe Vera 200x


I switched out the Dimethicone for Sensolene® which is a natural alternative to silicones.


Lastly, I used Geogard ECT instead of Phenonip® XB


Disclaimer; Unlike the first formula, I did not test out multiple versions of this moisturizer. I simply just switched out the ingredients that were not natural, for natural alternatives. This moisturizer ended up being much thinner and took a bit longer to rub in the skin and felt a bit heavier on the skin. It works fine as a body lotion, but not a face lotion.



Shop Same Ingredients I used

I am a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for me to earn fees by linking to Amazon.com and affiliated sites.

I am an affiliate with;

and some links may be affiliate links in this post. I will earn a small amount when you use my links at no cost to you.





Comments


bottom of page